Tent Half Wall Support Pole — Hardware Kit with Hex Clamps

A three-piece hardware kit that holds a printed half wall taut between two legs of a pop-up canopy tent. The telescopic pole feeds through the pole pocket sewn into the top of the half wall graphic and clamps to the tent legs at each end, so the graphic stays flat instead of sagging in the middle.

What's included

• One telescopic support pole
• Two hex clamps, one straight and one offset
• Use it on any side of the tent

What it fits

The hex clamps are sized for our hex aluminum tent frames, the same hardware used on our custom printed canopy tents. The pole is telescopic so it packs inside the tent carry case with the frame rather than travelling as a separate long item.

One kit per half wall

Each kit supports a single half wall. If you run half walls on three sides of the tent, you need three kits. This is hardware only, the printed half wall graphic is ordered separately.

Ordering from Miami

Ships free nationwide with fast dispatch from our Miami print studio. If you already run one of our custom canopy tents and need a replacement pole or clamp after a windy show, this is the part.